Creamy white matt decorative adhesive

Made to order in our workshop in France

Nos produits sont imprimés et découpés dans notre atelier, à Villars-les-Dombes. Nous proposons des collections exclusives avec des designs créés et imprimés dans notre studio. Chaque produit commandé sur notre site est réalisé aux mesures du client sans possibilité de rétractation. La couleur perçue peut varier suivant les écrans. Avant de passer commande, testez nos échantillons gratuits ! Et évitez ainsi de ne pas être satisfait, ou de vous tromper 😉
Demandez vos échantillons gratuits !

Frequently asked questions

• How to install adhesive coating yourself?

  All the steps and tips to follow can be found in our article "How to install an adhesive coating?"

• Can I put adhesive coating on my worktop?

  Yes, it's possible. Our coatings are thick, moisture-resistant and very easy to clean. There are a few precautions to take, such as using trivets. Find out more in our blog post "Can adhesive flooring be installed on a kitchen worktop?"

• Can the adhesive coating be removed without damaging the furniture underneath?

  You can remove the adhesive coating, but there's always a risk of damaging the surface underneath, as the adhesive is strong. Surfaces such as wallpaper or peeling paint are the most fragile.

  Our tip for removing adhesive coatings:

  • Start from a corner and pull fairly firmly
  • Use a release solution to cancel out the glue's action
  • Use a heat gun: the glue will soften the film and the adhesive. The adhesive coating is much easier to remove.

• Can adhesive coating be applied to a raised surface?

  Adhesive coatings can be applied to surfaces with relief, such as certain moldings. You need to master the application and thermoforming of the film, and ensure that the relief is not too pronounced.

  If you'd like to give it a try, you can test it with a free sample. Alternatively, you can call in a professional fitter.

• Can adhesive coating be applied to tiles?

  The adhesive coating can be applied to any smooth, non-porous surface. On tiles, it's possible. You'll need to be careful with the joints, as the hollows at the joints may show through.

  For a more aesthetic look, there are two solutions:

  • Smooth the surface with a smoothing compound beforehand
  • Cut tiles to size and reapply a clean grout over them

• How do I apply adhesive coating in corners?

  For a perfectly covered corner, follow our guide: "Successful installation of adhesive coverings in corners".